Cisco ME 3600X User Manual

-3
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
snmp mib rep trap-rate
snmp mib rep trap-rate
To configure the sending of Resilient Ethernet Protocol (REP) SNMP traps when there is a link
operational status or port role change, use the snmp mib rep trap-rate command in global configuration
mode. To disable sending of the REP trap, use the no version of the command.
snmp mib rep trap-rate value
no snmp mib rep trap-rate
Syntax Description
Defaults Sending REP traps is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to enable the switch to send REP specific traps corresponding to link operational
status changes and port role changes.
Examples This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10
Related Commands
trap-rate value Sets the number of REP traps sent per second. The range is from 0 to 1000. The
default is 0 (no limit imposed; a trap is sent at every occurrence).
Release Modification
12.2(52)EY This command was introduced.
Command Description
show running config Verifies that REP traps are configured.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English