B-12
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug matm
debug matm
To enable debugging of platform-independent MAC address management events, use the debug matm
command in privileged EXEC mode. To disable debugging, use the no form of this command.
debug matm {add | age | all | bulkdelete | create | delete | error | move | pm | remove | traceback}
no debug matm {add | age | all | bulkdelete | create | delete | error | move | pm | remove |
traceback}
Syntax Description
Note Although visible in the command-line help, the pvlan keyword is not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug matm command is the same as the no debug matm command.
Related Commands
add Displays MAC address add debug messages.
age Displays MAC address aging debug messages.
all Displays all MAC address debug messages.
bulkdelete Displays MAC address bulk delete debug messages.
create Displays MAC address creation debug messages.
delete Displays MAC address deletion debug messages.
error Displays MAC address creation debug messages.
move Displays MAC address move debug messages.
pm Displays MAC address port manager debug messages.
remove Displays MAC address remove debug messages.
traceback Displays MAC address traceback debug messages.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General