2-5
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
aggregate interval burst-cycles
aggregate interval burst-cycles
To configure an aggregate interval for burst-cycles for an IP Service Level Agreements (SLAs)
Metro-Ethernet 3.0 (Y.1731) operation, use the aggregate interval command in IP SLA Y.1731
synthetic loss configuration mode. To return to the default, use the no form of this command.
aggregate {interval} burst-cycles seconds
no aggregate interval
Syntax Description
Defaults The default aggregate interval is 1 seconds.
Command Modes IP SLA Y.1731 loss configuration (config-sla-y1731-loss)
Command History
Usage Guidelines An aggregate interval burst-cycle is the number of burst cycles on which the performance measurements
are conducted and teh resultes stored. Use this command to change the number of intervals for a frame
loss operation from the default (1 second) to the specified value.
The aggregate interval value must be less than the life value of the IP SLAs schedule. The default life
value for an IP SLAs schedule or IP SLAs multioperation group scheduler configuration is 3600 seconds.
Examples The following example shows how to configure a single-ended IP SLAs Ethernet delay operation with
an aggregate interval of 6 seconds:
Switch(config)# ip sla 10
Switch(config-ip-sla)# ethernet y7131 loss slm burst domain xxx evc yyy mpid 101 cos 3
source mpid 100
Switch(config-sla-y1731-delay)# aggregate interval burst-cycles 6
Switch(config-sla-y1731-delay)#
Related Commands
burst-cycles Specifies the number of burst-cycles
seconds Length of time in seconds. The range is from 1 to 65535. The default is 900.
Release Modification
15.2(4)S1 This command was introduced.
Command Description
distribution Configures statistics distributions for an IP SLAs Metro-Ethernet 3.0
(ITU-T Y.1731) operation.
history interval Sets the number of statistics distributions kept during the lifetime of
an IP SLAs Metro Ethernet 3.0 (ITU-T Y.1731) operation.
ip sla group schedule Configures multioperation scheduling for IP SLAs operations.
To Next Page
Loading...
Need help?
General