2-132
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
lacp max-bundle
lacp max-bundle
To configure the Link Aggregation Control Protocol (LACP) maximum number of ports to bundle in the
port channel, use the lacp max-bundle command in interface configuration mode. To return to the
default setting, use the no form of this command.
lacp max-bundle number-of-bundles
no lacp max-bundle
Syntax Description
Defaults The default is 8.
Command Modes Interface configuration
Command History
Usage Guidelines You can configure the maximum number of members that can be bundled. Any members in excess of
this maximum number are kept in hot-standby state and are transitioned to bundled state when one of the
bundled members goes down.
For information about configuring LACP on physical ports, see the “Configuring EtherChannels”
chapter in the software configuration guide for this release.
Examples This example shows how to configure the maximum number of ports to bundle in a port channel:
Switch(config)# interface port-channel 3
Switch(config-if)# lacp max-bundle 3
Related Commands
number-of-bundles Number of bundles. The range is 1 to 8.
Release Modification
15.3(1)S This command was introduced.
Command Description
show etherchannel summary Displays a one-line summary per channel-group
show etherchannel details Displays detailed EtherChannel information.
show etherchannel portchannel
number portchannel
Displays port-channel information.
show etherchannel summary Displays a one-line summary per channel-group.
show lacp internal Displays internal information for all channel groups or for
the specified channel group.
To Next Page
Loading...
Need help?
General