Cisco ME 3600X User Manual

2-78
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ethernet y1731 loss
ethernet y1731 loss
To configure a sender Maintenance End Point (MEP) for an IP Service Level Agreements (SLAs) Metro
Ethernet 3.0 (UIT-T Y.1731) frame loss operation, use the ethernet y1731 loss command in IP SLA
configuration mode.
ethernet y1731 loss SLM [burst] domain domain {{vlan | evc} value}{mpid | mac-address} value
cos value source {mpid | mac-address} value
Syntax Description
Defaults A sender MEP is not configured for the IP SLAs Metro-Ethernet 3.0 (ITU-T Y.1731) operation.
Command Modes IP SLA configuration (config-ip-sla)
Command History
Usage Guidelines This command begins configuring a sender MEP for an Ethernet Synthetic Loss Measurement
(ETH-SLM) and enters IP SLA Y.1731 loss configuration mode.
The SLM keyword for this command is not case sensitive. The keyword in online help contains
uppercase letters to enhance readability only.
You must configure CoS-level monitoring, use the monitor loss counter [priority cos range] command
under the EVC CFM sub-config mode for those interfaces that require loss monitoring.
To change the operation type of an existing IP SLAs operation, you must first use the no ip sla command
to delete the IP SLAs operation and then reconfigure the iperation with the new operation type.
SLM Specifies that the frames sent are Synthetic Loss Message (DMM)
synthetic frames.
burst Specifies that frames will be sent in a burst.
domain domain Specifies name of the Ethernet Connectivity Fault Management (CFM)
maintenance domain.
vlan Specifies the VLAN identification number. The range is from 1 to 4096.
evc Specifies the Ethernet Virtual Circuit (EVC) identification name.
mpid Specifies the maintenance endpoint identification numbers of the MEP
at the destination. The range is from 1 to 8191.
mac-address Specifies the MAC address of the MEP at the destination.
cos Specifies, for this MEP, which class of service (CoS) that will be sent
in the Ethernet connectivity fault management (CFM) message. The
range is from 0 to 7.
source mpid
List of maintenance endpoint identification numbers of the MEP being
configured. The range is from 1 to 8191.
source mac-address MAC address of the MEP being configured.
Release Modification
15.2(4)S This command was introduced.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English