2-75
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ethernet uni id
ethernet uni id
To create an Ethernet user-network interface (UNI) ID, use the ethernet uni command in interface
configuration mode.To remove the UNI ID, use the no form of this command.
ethernet uni id name
no ethernet uni id
Syntax Description
Defaults No UNI IDs are created.
Command Modes Interface configuration
Command History
Usage Guidelines When you configure a UNI ID on a port, that ID is used as the default name for all maintenance end
points (MEPs) configured on the port.
You must enter the ethernet uni id name command on all ports that are directly connected to
customer-edge (CE) devices. If the specified ID is not unique on the device, an error message appears.
Examples This example shows how to identify a unique UNI:
Switch(config-if)# ethernet uni id test2
Related Commands
name Identifies an Ethernet UNI ID. The name should be unique for all UNIs that
are part of a given service instance and can be up to 64 characters in length.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show interfaces Displays information about Ethernet service instances on an interface,
including service type.
To Next Page
Loading...
Need help?
General