2-36
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
clear logging onboard
clear logging onboard
To clear all the on-board failure logging (OBFL) data except for the uptime and CLI-command
information stored in the flash memory, use the clear logging onboard command in privileged EXEC
mode.
clear logging onboard [module {slot-number | all}]
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Usage Guidelines We recommend that you keep OBFL enabled and do not clear the data stored in the flash memory.
You can verify that the information was cleared by entering the show logging onboard onboard
privileged EXEC command.
Examples These examples show how to clear all the OBFL information except for the uptime and CLI-command
information:
Switch# clear logging onboard
Clear logging onboard buffer [confirm]
PID: ME-3400E-24TS-M , VID: 03 , SN: FOC1225U4CY
Switch# clear logging onboard module all
Clear logging onboard buffer [confirm]
PID: ME-3400E-24TS-M , VID: 03 , SN: FOC1225U4CY
Related Commands
module
{slot-number | all}
(Optional) The slot number is always 1 and is not relevant for the ME-3400E.
Entering clear logging onboard module 1 or clear logging onboard all has the
same result as entering clear logging onboard.
Release Modification
12.2(52)EY This command was introduced.
Command Description
hw-module module logging
onboard
Enables OBFL.
show logging onboard Displays OBFL information.
To Next Page
Loading...
Need help?
General