2-68
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
errdisable recovery
errdisable recovery
To configure the recover mechanism variables, use the errdisable recovery command in global
configuration mode. To return to the default setting, use the no form of this command.
errdisable recovery {cause {all | bpduguard | channel-misconfig | gbic-invalid | link-flap |
loopback | mac-limit | pagp-flap | oam-remote failure | port-mode failure |
ppoe-ia-rate-limit | storm-control | unicast-flood | | udld} | {interval interval}
no errdisable recovery {cause {all | bpduguard | channel-misconfig | gbic-invalid | link-flap |
loopback | mac-limit | pagp-flap | oam-remote failure | port-mode failure |
ppoe-ia-rate-limit | storm-control | unicast-flood | | udld} | {interval interval}
Note Although visible in the command-line help, the dhcp-rate-limit and psecure-violation keywords are
not supported.
Syntax Description cause Enables the error-disabled mechanism to recover from a specific cause.
all Enables the timer to recover from all error-disabled causes.
bpduguard Enables the timer to recover from the bridge protocol data unit (BPDU) guard
error-disabled state.
channel-misconfig Enables the timer to recover from the EtherChannel misconfiguration
error-disabled state.
gbic-invalid Enables the timer to recover from an invalid Gigabit Interface Converter
(GBIC) module error-disabled state.
Note This error refers to an invalid small form-factor pluggable (SFP)
error-disabled state.
link-flap Enables the timer to recover from the link-flap error-disabled state.
loopback Enables the timer to recover from a loopback error-disabled state.
mac-limit Enables the timer to recover from the MAC limit disable state.
oam-remote failure Enables the timer to recover from an Ethernet Operations, Administration,
and Maintenance (OAM) detected remote failure.
pagp-flap Enables the timer to recover from the Port Aggregation Protocol (PAgP)-flap
error-disabled state.
port-mode failure Enables the timer to recover from port mode change
ppoe-ia-rate-limit Enables the timer to recover from Point-to-Point Protocol over Ethernet
(PPPoE) IA rate-limit.
udld Enables the timer to recover from the UniDirectional Link Detection (UDLD)
error-disabled state.
unicast-flood Enables the timer to recover from the unicast flood disable state.
To Next Page
Loading...
Need help?
General