2-74
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ethernet oam remote-failure
ethernet oam remote-failure
To configure Ethernet operations, maintenance, and administration (EOM) remote failure indication, use
the ethernet oam remote-failure command in interface configuration or configuration template mode.
To remove the configuration, use the no form of this command.
ethernet oam remote-failure {critical-event | dying-gasp | link-fault} action
error-disable-interface
no ethernet oam remote-failure {critical-event | dying-gasp | link-fault} action
Syntax Description
Defaults Configuration template
Interface configuration
Command Modes Ethernet service configuration
Command History
Usage Guidelines You can apply this command to an Ethernet OAM template and to an interface. The interface
configuration takes precedence over template configuration. To enter OAM template configuration
mode, use the template template-name global configuration command.
The switch does not generate Link Fault or Critical Event OAM PDUs. However, if these PDUs are
received from a link partner, they are processed. The switch supports generating and receiving Dying
Gasp OAM PDUs when Ethernet OAM is disabled, the interface is shut down, the interface enters the
error-disabled state, or the switch is reloading. The switch can also generate and receive Dying Gasp
PDUs based on loss of power. The PDU includes a reason code to indicate why it was sent.
You can configure an error-disable action to occur if the remote link goes down, if the remote device is
disabled, or if the remote device disables Ethernet OAM on the interface.
For complete command and configuration for the Ethernet OAM protocol, see the Cisco IOS Carrier
Ethernet Configuration Guide at this URL:
http://www.cisco.com/en/US/docs/ios-xml/ios/cether/command/ce-cr-book.html
critical-event Configures the switch to put an interface in error-disabled mode when an
unspecified critical event has occurred.
dying-gasp Configures the switch to put an interface in error-disabled mode when an
unrecoverable condition has occurred.
link-fault Configures the switch to put an interface in error-disabled mode when the
receiver detects a loss of power.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General