-93
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
vlan access-map
vlan access-map
To create or modify a VLAN map entry for VLAN packet filtering and to enter VLAN access-map
configuration mode, use the vlan access-map command in global configuration mode. To delete a
VLAN map entry, use the no form of this command. Use the vlan filter interface configuration command
to apply a VLAN map to one or more VLANs.
vlan access-map name [number]
no vlan access-map name [number]
Syntax Description
Defaults There are no VLAN map entries and no VLAN maps applied to a VLAN.
Command Modes Global configuration
Command History
Usage Guidelines In global configuration mode, use this command to create or modify a VLAN map. This entry changes
the mode to VLAN access-map configuration, where you can use the match access-map configuration
command to specify the access lists for IP or non-IP traffic to match and use the action command to set
whether a match causes the packet to be forwarded or dropped.
In VLAN access-map configuration mode, these commands are available:
• action: sets the action to be taken (forward or drop).
• default: sets a command to its defaults
• exit: exits from VLAN access-map configuration mode
• match: sets the values to match (IP address or MAC address).
• no: negates a command or set its defaults
When you do not specify an entry number (sequence number), it is added to the end of the map.
There can be only one VLAN map per VLAN and it is applied as packets are received by a VLAN.
You can use the no vlan access-map name [number] command with a sequence number to delete a single
entry.
In global configuration mode, use the vlan filter interface configuration command to apply the map to
one or more VLANs.
name Name of the VLAN map.
number (Optional) The sequence number of the map entry that you want to create or modify (0
to 65535). If you are creating a VLAN map and the sequence number is not specified,
it is automatically assigned in increments of 10, starting from 10. This number is the
sequence to insert to, or delete from, a VLAN access-map entry.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General