B-19
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug rep
debug rep
To enable debugging of Resilient Ethernet Protocol (REP) functions, use the debug rep command in
privileged EXEC mode. To disable debugging, use the no form of this command.
debug rep {all | bpa-event | bpasm | database | epa-pkt | epasm | error | failure-recovery | lslsm
| misc | packet | prsm |show cli}
no debug rep {all | bpa-event | bpasm | database | epa-pkt | epasm | error | failure-recovery |
lslsm | misc | packet | prsm |show cli}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug rep command is the same as the no debug rep command.
Related Commands
all Display all REP debug messages.
bpa-event Displays blocked port advertisement (BPA) debug messages.
bpasm Displays BPA state machine debug messages.
database Displays REP state machine debug messages.
epa-pkt Displays end port advertisement (EPA) packet debug messages.
epasm Displays EPA state machine debug messages.
error Displays REP protocol error debug messages.
failure-recovery Displays REP switchover event debug messages.
lslsm Displays Link State Layer (LSL) state machine debug messages.
misc Displays miscellaneous REP debug messages.
packet Displays protocol PDU debug messages.
prsm Displays REP port role state machine debug messages.
showcli Displays show command line interface debug information.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show interfaces rep Displays REP configuration and status for a specified interface or for all
interfaces.
To Next Page
Loading...
Need help?
General