2-101
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ip igmp filter
ip igmp filter
To control whether or not all hosts on a Layer 2 interface can join one or more IP multicast groups by
applying an Internet Group Management Protocol (IGMP) profile to the interface, use the ip igmp filter
command in interface configuration mode. To remove the specified profile from the interface, use the no
form of this command.
ip igmp filter profile number
no ip igmp filter
Syntax Description
Defaults No IGMP filters are applied.
Command Modes Interface configuration
Command History
Usage Guidelines You can apply IGMP filters only to Layer 2 physical interfaces.
You cannot apply IGMP filters to routed ports, switch virtual interfaces (SVIs), or ports that belong to
an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
You can verify your setting by using the show running-config privileged EXEC command and by
specifying an interface.
Examples This example shows how to apply IGMP profile 22 to a port.
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# ip igmp filter 22
Related Commands
profile number The IGMP profile number to be applied. The range is 1 to 4294967295.
Release Modification
12.2(52)EY This command was introduced.
Command Description
ip igmp profile Configures the specified IGMP profile number.
show ip igmp profile Displays the characteristics of the specified IGMP profile.
show running-config interface
interface-id
Displays the running configuration on the switch interface, including
the IGMP profile (if any) that is applied to an interface.
To Next Page
Loading...
Need help?
General