-83
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
show ip igmp snooping groups
show ip igmp snooping groups
To display the Internet Group Management Protocol (IGMP) snooping multicast table or multicast
information for the switch, use the show ip igmp snooping groups command in privileged EXEC
command. To display the multicast table for a specified multicast VLAN or to diplay specific multicast
information, use with the vlan keyword.
show ip igmp snooping groups [count] [ | {begin | exclude | include} expression]
show ip igmp snooping groups vlan vlan-id [ip_address | count] [ | {begin | exclude | include}
expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command to display multicast information or the multicast table.
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
count
(Optional) Displays the total number of entries for the specified command
options instead of the actual entries.
ip_address (Optional) Displays characteristics of the multicast group with the specified group
IP address.
vlan-id (Optional) Specifies a VLAN; the range is 1 to 1001 and 1006 to 4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General