Cisco ME 3600X User Manual

2-45
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
controller BITS input applique
controller BITS input applique
To configure the Building Integrated Timing Supply (BITS) clock input link type and characteristics, use
the controller BITS input applique command in global configuration mode. To remove the
configuration, use the no form of this command.
controller BITS input applique E1{2048KHz | framing {fas_crc4 | fas_nocrc | |mfas_crc4 |
mfas_nocre} linecode {ami | hdb3}
controller BITS input applique T1 framing {d4 | esf} linecode {ami | b8zs}
no controller BITS input applique
Syntax Description
Defaults The default input timing is E1.
Command Modes Global configuration
Command History
E1 2048 KHz Specifies an EI timing signal input of 2048 KHz.
E1 framing Specifies an EI signal input and specify the framing mode as one of these
options:
• fas_crc4—FASCRC4
• fas_nocrc—FAS
• mfas_crc4—MFASCRC4
• mfas_nocre—MFAS
linecode (EI) Selects the E1 line coding:
• ami—AMI encoding
• hdb3—HDB3 encoding
T1 framing Specifies a T1 (1.544 MHz) signal input and specify the framing mode as one
of these options:
• d4—D4
• esf—Extended Superframe
linecode (T1) Selects the T1 line coding:
• ami—AMI encoding
• b8zs—B8ZS encoding
Release Modification
12.2(52)EY This command was introduced.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English