B-16
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug pagp
debug pagp
To enable debugging of Port Aggregation Protocol (PAgP) activity, use the debug pagp command in
privileged EXEC mode. To disable debugging, use the no form of this command.
debug pagp [all | dual-active | event | fsm | misc | packet]
no debug pagp [all | dual-active | event | fsm | misc | packet]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug pagp command is the same as the no debug pagp command.
Related Commands
all (Optional) Displays all PAgP debug messages.
dual-active (Optional) Displays PAgP dual-active debug messages.
event (Optional) Displays PAgP event debug messages.
fsm (Optional) Displays PAgP finite state-machine debug messages.
misc (Optional) Displays miscellaneous PAgP debug messages.
packet (Optional) Displays PAgP packet debug messages.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show pagp Displays PAgP channel-group information.
To Next Page
Loading...
