-36
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
show controllers cpu-interface
show controllers cpu-interface
To display the state of the CPU network interface ASIC and the send and receive statistics for packets
reaching the CPU, use the show controllers cpu-interface command in privileged EXEC mode.
show controllers cpu-interface [ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines This display provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is a partial output example from the show controllers cpu-interface command:
Switch# show controllers cpu-interface
Queue cnt normal jumbo normal-err jumbo-err dropped unfill
--------------------------------------------------------------------------------
sw forwarding 0 0 0 0 0 0
routing protocol 0 0 0 0 0 0
icmp 0 0 0 0 0 0
host 0 0 0 0 0 0
acl logging 0 0 0 0 0 0
stp 36 0 0 0 0 0
l2 protocol 14357 0 0 0 0 0
mcast control 18862 0 0 0 0 0
broadcast 0 0 0 0 0 0
rep 0 0 0 0 0 0
cfm 0 0 0 0 0 0
control? 0 0 0 0 0 0
ip mpls ttl 0 0 0 0 0 0
ipmcast default 0 0 0 0 0 0
route data 0 0 0 0 0 0
ipmcast mismatch 0 0 0 0 0 0
ipmcast rpf-fail 0 0 0 0 0 0
routing throttle 0 0 0 0 0 0
ipmcast? 0 0 0 0 0 0
<output truncated>
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General