B-31
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug sw-vlan
debug sw-vlan
To enable debugging of VLAN manager activities, use the debug sw-vlan command in privileged EXEC
mode. To disable debugging, use the no form of this command.
debug sw-vlan {badpmcookies | cfg-vlan {bootup | cli} | events | ifs | management | notification
| packets | registries}
no debug sw-vlan {badpmcookies | cfg-vlan {bootup | cli} | events | ifs | management |
notification | packets | registries}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug sw-vlan command is the same as the no debug sw-vlan command.
Related Commands
badpmcookies Displays debug messages for VLAN manager incidents of bad port manager
cookies.
cfg-vlan {bootup | cli} Displays config-vlan debug messages. The keywords have these meanings:
• bootup—Display messages when the switch is booting up.
• cli—Display messages when the command-line interface (CLI) is in
config-vlan mode.
events Displays debug messages for VLAN manager events.
ifs See the debug sw-vlan ifs command.
management Displays debug messages for VLAN manager management of internal
VLANs.
notification See the debug sw-vlan notification command.
packets Displays debug messages for packet handling and encapsulation processes.
registries Displays debug messages for VLAN manager registries.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show vlan Displays the parameters for all configured VLANs or one VLAN (if the
VLAN name or ID is specified) in the administrative domain.
To Next Page
Loading...
Need help?
General