Cisco ME 3600X User Manual

-76
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
show interfaces transceiver
show interfaces transceiver
To display the physical properties of a small form-factor pluggable (SFP) module interface, use the show
interfaces transceiver command in privileged EXEC mode.
show interfaces [interface-id] transceiver [detail | module number | properties | supported-list |
threshold-table] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines The threshold values shown in the outputs from the show interfaces transceiver threshold-table and
the show interfaces transceiver detail are not the same. The thresholds shown in the output from the
show interfaces transceiver threshold-table command are hard-coded in Cisco IOS, but are not
supported.
The thresholds shown in the output from the show interfaces transceiver detail command are read from
the SFP EEPROM and are supported. You should always use the show interfaces transceiver detail
command to view transceiver thresholds.
interface-id (Optional) Displays configuration and status for a specified physical
interface.
detail (Optional) Displays calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring
(DoM)-capable transceiver if one is installed in the switch.
supported-list (Optional) Lists all supported DoM transceivers.
threshold-table (Optional) Displays alarm and warning threshold table.
Note This keyword displays the thresholds that are programmed into SFP
hardware and are not those used to determine when to send alarms or
traps. To view those thresholds, enter the show interfaces
transceiver detail command.
module number (Optional) Limits display to interfaces on module on the switch. The range
is 1 to 9. This option is not available if you entered a specific interface ID.
properties (Optional) Displays speed, duplex, and inline power settings on an interface.
threshold-table (Optional) Displays alarm and warning threshold table
| begin (Optional) Display begins with the line that matches the expression
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)EY This command was introduced.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English