-71
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
show interfaces counters
show interfaces counters
To display various counters for the switch or for a specific interface, use the show interfaces counters
command in privileged EXEC mode.
show interfaces [interface-id | vlan vlan-id] counters [errors | trunk] [module switch- number] |
etherchannel | protocol status] [ | {begin | exclude | include} expression]
Syntax Description
Note Though visible in the command-line help string, the vlan vlan-id keyword is not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not enter any keywords, all counters for all interfaces are included.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
interface-id (Optional) ID of the physical interface, including type, module, and port
number.
errors (Optional) Displays error counters.
trunk (Optional) Displays trunk counters.
module switch- number (Optional) Displays counters for the specified switch number. The only
available value is 1.
etherchannel (Optional) Displays EtherChannel counters, including octets, broadcast
packets, multicast packets, and unicast packets received and sent.
protocol status (Optional) Displays status of protocols enabled on interfaces.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General