-96
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
vlan filter
vlan filter
To apply a VLAN map to one or more VLANs, use the vlan filter command in global configuration
mode. To remove the map, use the no form of this command.
vlan filter mapname vlan-list {list | all}
no vlan filter mapname vlan-list {list | all}
Syntax Description
Defaults There are no VLAN filters.
Command Modes Global configuration
Command History
Usage Guidelines To avoid accidentally dropping too many packets and disabling connectivity in the middle of the
configuration process, we recommend that you completely define the VLAN access map before applying
it to a VLAN.
You can verify your settings by entering the show vlan filter privileged EXEC command.
For more information about VLAN map entries, see the software configuration guide for this release.
Examples This example applies VLAN map entry map1 to VLANs 20 and 30:
Switch(config)# vlan filter map1 vlan-list 20, 30
This example shows how to delete VLAN map entry mac1 from VLAN 20:
Switch(config)# no vlan filter map1 vlan-list 20
Related Commands
mapname Name of the VLAN map entry.
list The list of one or more VLANs in the form tt, uu-vv, xx, yy-zz, where spaces
around commas and dashes are optional. The range is 1 to 4094.
all Removes the filter from all VLANs.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show vlan access-map Displays information about a particular VLAN access map or all VLAN
access maps.
show vlan filter Displays information about all VLAN filters or about a particular VLAN
or VLAN access map.
vlan access-map Creates a VLAN map entry for VLAN packet filtering.
To Next Page
Loading...
Need help?
General