-135
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
show port-type
show port-type
To display interface type information for the Cisco ME switch, use the show port-type command in
privileged EXEC mode.
show port-type [eni | nni | uni] [ | {begin | exclude | include} expression]
Note All ports on the switch are network node interfaces (NNIs), so only nni output is valid.
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines If you enter the command without keywords, the output includes the interface type information for all
ports on the switch. If you specify the port type (eni, nni, or uni), the output includes information for
the specified port type.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show port-type command. The output is the same for show
port-type and show port-type nni:
Switch# show port-type nni
Port Name Vlan Port Type
--------- ------------------ ---------- ----------------------------
Gi0/1 trunk Network Node Interface (nni)
Gi0/2 trunk Network Node Interface (nni)
Gi0/3 trunk Network Node Interface (nni)
Gi0/4 1 Network Node Interface (nni)
Gi0/5 1 Network Node Interface (nni)
Gi0/6 routed Network Node Interface (nni)
Gi0/7 1 Network Node Interface (nni)
Gi0/8 1 Network Node Interface (nni)
Gi0/9 1 Network Node Interface (nni)
eni Enhanced network interface.
nni Network node interface.
uni User network interface.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General