Cisco ME 3600X User Manual

-65
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
show interfaces
Note Though visible in the command-line help strings, the crb, private-vlan mapping, pruning
random-detect, and rate-limit keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
• Use the show interface capabilities module 1 to display the capabilities of all interfaces on the
switch. Entering any other number is invalid.
• Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
• Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
• Use the show interface switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Entering any other number is invalid.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show interfaces command for an interface:
Switch# show interfaces gigabitethernet0/1
GigabitEthernet0/1 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0023.eb17.c781 (bia 0023.eb17.c781)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:14, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
28980 packets input, 2882755 bytes, 0 no buffer
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)EY This command was introduced.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English