5-17
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
• key-string — encryption key that the server and client will use when communicating with each
other. Make sure that the specified key is actually configured on the TACACS+ server host.
–
Default = no key or user-configured global default key (see How to Define a Global Default Key,
page 5-17.)
Step 1 From the SCE(config)# prompt, type TACACS-server host host-name [port portnumber] [timeout
timeout-interval] [key key-string] and press Enter.
How to Remove a TACACS+ Server Host
Options
The following options are available:
• host-name — name of the server to be deleted
Step 1 From the SCE(config)# prompt, type no TACACS-server host host-name and press Enter.
How to Configure the Global Default Key
Use this command to define the global default key for the TACACS+ server hosts. This default key can
be overridden for a specific TACACS+ server host by explicitly configuring a different key for that
TACACS + server hos t .
• Options, page 5-17
• How to Define a Global Default Key, page 5-17
• How to Clear the Global Default Key, page 5-18
Options
The following options are available:
• key-string — default encryption key that all TACACS+ servers and clients will use when
communicating with each other. Make sure that the specified key is actually configured on the
TACACS+ server hosts.
–
Default = no encryption
How to Define a Global Default Key
Step 1 From the SCE(config)# prompt, type TACACS-server key key-string and press Enter.
To Next Page
Loading...
