Cisco SCE2020-4XGBE-SM - Page 112

5-18
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
How to Clear the Global Default Key
Step 1 From the SCE(config)# prompt, type no TACACS-server key and press Enter.
No global default key is defined. Each TACACS+ server host may still have a specific key defined.
However, any server host that does not have a key explicitly defined (uses the global default key) is now
configured to use no key.
How to Configure the Global Default Timeout
Use this command to define the global default timeout interval for the TACACS+ server hosts. This
default timeout interval can be overridden for a specific TACACS+ server host by explicitly configuring
a different timeout interval for that TACACS+ server host.
• Options, page 5-18
• How to Define the Global Default Timeout, page 5-18
• How to Clear the Global Default Timeout, page 5-18
Options
The following options are available:
• timeout interval — default time in seconds that the server waits for a reply from the server host
before timing out.
– Default = 5 seconds
How to Define the Global Default Timeout
Step 1 From the SCE(config)# prompt, type TACACS-server timeout timeout-interval and press Enter.
How to Clear the Global Default Timeout
Step 1 From the SCE(config)# prompt, type no TACACS-server timeout and press Enter.
No global default timeout interval is defined. Each TACACS+ server host may still have a specific
timeout interval defined. However, any server host that does not have a timeout interval explicitly
defined (uses the global default timeout interval) is now configured to a five second timeout interval.