Cisco SCE2020-4XGBE-SM - Page 13

Contents
xi
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Configuring Data Destinations and Categories 8-6
Configuring a Data Destination 8-6
Options 8-7
Configuring the Data Destinations: Examples 8-7
Configuring the Data Categories 8-8
How to Configure a Destination and Assign Categories 8-8
Configuring the Forwarding Mode 8-12
Options 8-13
Configuring the Forwarding Mode: Example 8-13
Configuring the RDR Formatter 8-13
Options 8-13
How to Enable the RDR Formatter 8-13
How to Disable the RDR Formatter 8-14
How to Configure the Size of the RDR Formatter History Buffer 8-14
Options 8-14
Configuring the NetFlow Exporting Support 8-14
Options 8-14
How to Configure a DSCP Value for NetFlow 8-15
Options 8-15
How to Configure the Template Refresh Interval 8-15
Options 8-15
Configuring Dynamic Mapping of RDRs to Categories 8-15
How to Configuring Mappings 8-16
Options 8-16
How to Add a Mapping to a Category 8-16
How to Remove a Mapping from a Category 8-16
How to Restore the Default Mapping for a Specified RDR Tag 8-16
Displaying Data Destination Configuration and Statistics 8-17
How to the Display the Current RDR Formatter Configuration 8-17
Displaying the RDR Formatter Configuration: Example 8-17
How to the Display the Current RDR Formatter Statistics 8-18
Displaying the Current RDR Formatter Statistics: Example 8-18
Disabling the Linecard from Sending RDRs 8-19
How to Disable the Linecard from Sending RDRs 8-19
How to Enable the Linecard to Send RDRs 8-19
CHAPTER 9 Managing Subscribers 9-1
Introduction 9-1
Information About Subscribers 9-1