Cisco SCE2020-4XGBE-SM - Page 12

Contents
x
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Monitoring Asymmetric Routing: Example 7-9
Configuring a Forced Failure 7-9
How to Force a Virtual Failure 7-9
How to Exit from a Virtual Failure 7-9
Configuring the Failure Recovery Mode 7-9
Options 7-10
Configure the Failure Recovery Mode: Examples 7-10
Example 1 7-10
Example 2 7-10
Configuring the SCE Platform/SM Connection 7-10
Configuring the Behavior of the SCE Platform in Case of Failure of the SM 7-11
Options 7-11
Configuring the SM-SCE Platform Connection Timeout 7-11
Options 7-11
Enabling and Disabling Link Failure Reflection 7-12
How to Enable Link Failure Reflection 7-12
How to Disable Link Failure Reflection 7-12
Enabling and Disabling Link Failure Reflection on All Ports 7-12
Options 7-13
How to Enable Link Failure Reflection on All Ports 7-13
How to Disable Link Failure Reflection on All Ports 7-13
Configuring Link Failure Reflection in Linecard-Aware Mode (SCE 2000 only) 7-13
How to Enable Linecard-Aware Mode 7-14
How to Disable Linecard-Aware Mode 7-14
CHAPTER 8 Raw Data Formatting: The RDR Formatter and NetFlow Exporting 8-1
Introduction 8-1
Information About the RDR Formatter and NetFlow Exporting Support 8-1
The RDR Formatter 8-2
NetFlow 8-2
NetFlow Terminology 8-2
NetFlow Exporting Support 8-3
Data Destinations 8-3
Categories 8-4
Priority 8-5
Setting DSCP for NetFlow 8-5
Forwarding Modes 8-5
Protocol 8-6
Transport Type 8-6