Contents
ix
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
How to Delete a Traffic Counter 6-20
How to Delete all Existing Traffic Counters 6-20
Configuring Traffic Rules 6-20
How to Create a Traffic Rule 6-20
How to Delete a Traffic Rule 6-24
How to Delete all Traffic Rules 6-24
How to Delete All Flow Control Traffic Rules 6-24
Managing Traffic Rules and Counters 6-25
How to View a Specified Traffic Rule 6-25
How to View all Traffic Rules 6-25
How to View a Specified Traffic Counter 6-25
How to View all Traffic Counters 6-26
How to Reset a Specified Traffic Counter 6-26
How to Reset all Traffic Counters 6-26
TOS Marking 6-26
How to Display the TOS Marking Configuration 6-27
Counting Dropped Packets 6-27
Configuring the Hardware Packet Drop 6-27
How to Disable the Hardware Packet Drop 6-27
How to Enable the Hardware Packet Drop 6-28
CHAPTER
7 Configuring the Connection 7-1
Introduction 7-1
Configuring the Connection Mode 7-1
Options 7-2
Configuring the Connection Mode: Examples 7-3
Monitoring the Connection Mode and Related Parameters 7-3
How to View the Current Connection Mode 7-3
How to View the SCE-ID 7-4
How to View the Current Redundancy Status of the SCE Platform 7-4
How to View Information about the Peer SCE Platform 7-5
How to View the Current Connection Status of the SCE Platform 7-5
How to Configure the Link Mode 7-5
About the Link Mode 7-6
Options 7-6
Configuring Asymmetric Routing Topology 7-7
Asymmetric Routing and Other Service Control Capabilities 7-8
Enabling Asymmetric Routing 7-8
How to Monitor Asymmetric Routing 7-8
To Next Page
Loading...
