Contents
viii
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
How to Configure the Speed of the Management Interface 5-71
Monitoring the Management Interface 5-72
CHAPTER
6 Configuring the Line Interface 6-1
Introduction 6-1
Line Interfaces 6-1
Flow Control and Bandwidth Considerations 6-2
Configuring the Gigabit Ethernet Line Interfaces 6-2
How to Configure a Specific Gigabit Ethernet Line Interface 6-2
How to Configure a Range of Gigabit Ethernet Line Interfaces 6-3
Tunneling Protocols 6-3
Managed VPNs 6-5
Selecting the Tunneling Mode 6-6
Configuring L2TP IP Tunnels 6-7
IPinIP Tunneling 6-7
Configuring DSCP Marking for IPinIP Tunnels 6-9
Configuring the VLAN Environment 6-10
Configuring the MPLS Environment 6-11
Configuring the L2TP Environment 6-12
Asymmetric L2 Support 6-13
Displaying the Tunneling Configuration 6-13
How to Display the IPinIP Configuration 6-14
How to Display the Logged-in VPNs 6-14
Options 6-14
How to Display the Asymmetric L2 Support Mode 6-14
Configuring VLAN Translation 6-14
VLAN Translation Features and Limitations 6-15
Setting the VLAN Translation Constant 6-16
Options 6-16
Setting the VLAN Translation Constant: Example 6-16
How to Disable VLAN Translation 6-17
How to Monitor VLAN Translation 6-17
Configuring Traffic Rules and Counters 6-17
Information About Traffic Rules and Counters 6-17
What are Traffic Rules and Counters? 6-18
Traffic Rules 6-18
Traffic Counters 6-19
Configuring Traffic Counters 6-19
How to Create a Traffic Counter 6-20
To Next Page
Loading...
