Cisco SCE2020-4XGBE-SM - Page 22

Contents
xx
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
How to Remove the IP Address Configuration 12-44
How to Enable the Health Check for VAS over 10G Topology 12-45
Options 12-45
How to Enable Health Check Compatibility for VAS over 10G (MGSCP) 12-45
How to Remove the Health Check Compatibility Configuration 12-45
VAS Over 10G Sample Configuration 12-46
Intelligent Traffic Mirroring 12-47
Behavioral Targeting Use Case 12-47
Traffic Mirroring and SCA BB 12-48
Mirroring Termination 12-48
Mirroring Exceptions 12-49
SCE Connectivity 12-49
Configuring Traffic Mirroring 12-50
Monitoring Traffic Mirroring 12-51
Traffic Mirroring Sample Configuration 12-52
CHAPTER 13 MPLS/VPN Support 13-1
Introduction 13-1
Service Control in the MPLS/VPN Environment 13-1
Definitions and Acronyms 13-2
What are the Challenges for Service Control for MPLS/VPN Support? 13-3
How MPLS/VPN Support Works 13-3
Flow Detection 13-3
VPN Detection 13-4
Subscriber Detection 13-4
What is an MPLS/VPN-based Subscriber? 13-4
Private IP Subscriber Support 13-5
How the Service Control MPLS/VPN Solution Works 13-5
How the Service Control MPLS/VPN Solution Works: A Summary 13-5
SCE Platform Tasks in the MPLS/VPN Solution 13-5
BGP LEG Tasks in the MPLS/VPN Solution 13-6
SM Tasks in the MPLS/VPN Solution 13-6
Service Control MPLS/VPN Concepts 13-6
Non-VPN-Based Subscribers 13-6
Bypassing Unknown VPNs 13-7
Additional MPLS Pattern Support 13-7
VPN Identifier (RD or RT) 13-8
Service Control MPLS/VPN Requirements 13-8
Topology 13-8