Cisco SCE2020-4XGBE-SM - Page 24

Contents
xxii
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Single ISG Router with Two Cascaded SCE Platforms (1xISG – 2xSCE) 14-4
Multiple ISG Routers with Two Cascaded SCE Platforms (NxISG – 2xSCE) 14-5
Multiple ISG Routers with Multiple SCE Platforms via Load Balancing (NxISG – MxSCE) 14-6
SCMP Peer Devices 14-7
Connection Management 14-7
SCMP Subscriber Management 14-8
GUID and Subscriber ID 14-8
Configuring the SCMP 14-8
Configuring SCMP Parameters 14-9
How to Enable the SCMP 14-9
How to Disable the SCMP 14-9
Configuring the SCMP Peer Device to Push Sessions 14-9
Configuring the SCMP Peer Device to Force Each Subscriber to Single SCE Platform 14-10
How to Define the Keep-alive Interval Parameter 14-11
How to Define the Reconnect Interval Parameter 14-11
How to Define the Loss-of-Sync Timeout Parameter 14-11
Adding an SCMP Peer Device 14-12
How to Define an SCMP Peer Device 14-12
Assigning the SCMP Peer Device to an Anonymous Group 14-13
Deleting Subscribers Managed by an SCMP Peer Device 14-13
Options 14-13
Deleting an SCMP Peer Device 14-14
Defining the Subscriber ID 14-14
Options 14-15
Configuring the RADIUS Client 14-15
Options 14-16
Monitoring the SCMP Environment 14-16
Monitoring the SCMP 14-16
Options 14-16
How to display the general SCMP configuration 14-17
How to display the configuration all currently defined SCMP peer devices 14-17
How to display the configuration for a specified SCMP peer device 14-17
How to display the statistics for all SCMP peer devices 14-17
How to display the statistics for a specified SCMP peer device 14-18
Monitoring the RADIUS Client 14-18
APPENDIX A Monitoring SCE Platform Utilization A-1
Introduction A-1
SCE Platform Utilization Indicators A-2