CTS FOS-3126-PLUS SERIES - Page 44

44
No command
Switch(config)# no dot1x
Disable IEEE 802.1x function.
Switch(config)# no dot1x reauth-
period
Reset the re-authentication period
value back to the default setting (60
seconds).
Switch(config)# no dot1x
reauthentication
Disable re-authentication function.
Switch(config)# no dot1x secret
Remove the original shared secret.
Switch(config)# no dot1x server
Remove the specified server IP
address.
Switch(config)# no dot1x timeout
Reset the timeout value back to the
default setting (10 seconds).
Show command
Switch(config)# show dot1x
Show or verify 802.1x settings.
Switch(config)# show dot1x
interface
Show or verify each interface‟s
802.1x settings including port status
and authentication status.
Switch(config)# show dot1x
interface [port_list]
[port_list]
Show or verify the selected
interfaces‟ 802.1x settings including
port status and authentication status.
Switch(config)# show dot1x
statistics
Show or verify 802.1x statistics.
Switch(config)# show dot1x
statistics [port_list]
[port_list]
Show or verify the selected
interfaces‟ statistics.
Switch(config)# show dot1x
status
Show or verify 802.1x status.
Switch(config)# show dot1x
status [port_list]
[port_list]
Show or verify the selected
interfaces‟ 802.1x status.
Dot1x command example
Switch(config)# dot1x
Enable IEEE 802.1x function.
Switch(config)# dot1x reauth-period 3600
Set the reauthentication period to
3600 seconds.
Switch(config)# dot1x reauthentication
Enable re-authentication function.
Switch(config)# dot1x secret agagabcxyz
Set the shared secret to
“agagabcxyz”
Switch(config)# dot1x server 192.168.1.10
Set the 802.1x server IP address to
192.168.1.10.
Switch(config)# dot1x timeout 120
Set the timeout value to 120
seconds.