Use “Interface” command to configure a group of ports’ IEEE 802.1x settings.
Dot1x & Interface command
Switch(config)# interface [port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)#
dot1x port-control [auto |
unauthorized]
Specify the selected ports to “auto” or
“unauthorized”.
“auto”: This requires 802.1X-aware
clients to be authorized by the
authentication server. Accesses from
clients that are not dot1x aware will be
denied.
“unauthorized”: This forces the
Managed Switch to deny access to all
clients, neither 802.1X-aware nor
802.1X-unaware.
“authorized”: This forces the
Managed Switch to grant access to all
clients, both 802.1X-aware and
802.1x-unaware. No authentication
exchange is required. By default, all
ports are set to “authorized”.
Switch(config-if-PORT-PORT)#
dot1x reauthenticate
Re-authenticate the selected
interfaces.
Switch(config)# interface [port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)# no
dot1x port-control
Reset the selected interfaces‟ 802.1x
state to the factory default (authorized
state).
Switch(config)# show dot1x
Show or verify 802.1x settings.
Switch(config)# show dot1x
interface
Show or verify each interface‟s 802.1x
settings including port status and
authentication status.
Switch(config)# show dot1x
interface [port_list]
Show or verify the selected interfaces‟
802.1x settings including port status
and authentication status.
Switch(config)# show dot1x
statistics
Show or verify 802.1x statistics.
Switch(config)# show dot1x
statistics [port_list]
Show or verify the selected interfaces‟
statistics.
Switch(config)# show dot1x status
Show or verify 802.1x status.
Switch(config)# show dot1x status
[port_list]
Show or verify the selected interfaces‟
802.1x status.
To Next Page
Loading...
