DES-3000 Series Layer 2 Switch CLI Reference Manual
Command Parameters
config cos mapping
[<portlist>|all]
[none |{port_mapping | ethernet [802.1p | mac_mapping | ip [tos | dscp]]}]
show cos mapping
{port <portlist> | all }
config dscp_mapping dscp_value <0 – 63> [ class <class_id 0-3> ]
show dscp_mapping { dscp_value <value 0-63> }
config scheduling <class_id 0-3> weight <value 1-55>
show scheduling
config 802.1p user_priority
<pri
ority 0-7> <class_id 0-3> show 802.1p user_priority
config 802.1p default_priority
[<por
tlist> | all] <priority 0-7> show 802.1p default_priority
{<portlist>}
config scheduling_mechanism [strict | weight_fair]
show scheduling_mechanism
config bandwidth_control
[<portlist>] {r
x_rate [no_limit | <value 64-1024000>] | tx_rate [no_limit <value 64-1024000>]}
show bandwidth_control
{<portlist>}
config cos port_mapping [class <class_id 0 | 3>] [<portlist> | all ]
show cos port_mapping
{port <portlist> }
config cos mac_mapping
destination_addr
<macaddr> [class <class_id 0-3>]
show cos mac_mapping { destination_addr < macaddr > }
config cos tos value <value 0-7> [class <class_id 0-3>]
show cos tos { value <value 0-7> }
Each command is listed, in detail, in the following sections.
96
To Next Page
Loading...
Need help?
General
