DES-3000 Series Layer 2 Switch CLI Reference Manual
Example usage:
To view SIM neighbors:
DES-3026:4#show sim neighbor
Command: show sim neighbor
Neighbor Info Table
------ ------------------ ---------
Port MAC Address Role
23 00-35-26-00-11-99 Commander
23 00-35-26-00-11-91 Member
24 00-35-26-00-11-90 Candidate
Total Entries: 3
DES-3026:4#
reconfig
Purpose Used to connect to a member switch, through the commander switch
using telnet.
Syntax
reconfig [member_id <value 1-32> | exit]
Description This command is used to reconnect to a member switch using telnet.
Parameters member_id <value 1-32> - Select the ID number of the member
switch to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To connect to the MS, with member id 2, through the CS, using the command line interface:
DES-3026:4#reconfig member_id 2
DES-3026:4#
Command: reconfig member_id 2
203
To Next Page
Loading...
