DES-3000 Series Layer 2 Switch CLI Reference Manual
To enable HTTP and configure port number:
DES-3026:4#enable web 80
Command: enable web 80
Success.
DES-3026:4#
disable web
Purpose Used to disable the HTTP-based management software on the
Switch.
Syntax
disable web
Description This command disables the Web-based management software on
the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable HTTP:
DES-3026:4#disable web
Command: disable web
Success.
DES-3026:4#
save
Purpose Used to save changes in the Switch’s configuration to non-volatile
RAM.
Syntax
Save {config | log | all }
Description This command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch’s memory each time the Switch is restarted.
Parameters config – Save configuration to NV-RAM.
log – Save history log.
all – Save configuration and log.
Restrictions Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DES-3026:4#save
Command: save
Saving all configurations to NV-RAM... Done.
18
To Next Page
Loading...
