DES-3000 Series Layer 2 Switch CLI Reference Manual
show packet ports
Purpose Used to display statistics about the packets sent and received by the
Switch.
Syntax
show
packet ports <portlist>
Description This command is used to display statistics about packets sent and
received by ports specified in the port list. The results are separated
into three tables, labeled A, B, and C in the window above. Table A
is relevant to the size of the packets, Table B is relevant to the type
of packets and Table C is relevant to the type of frame associated
with these packets.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the packets analysis for port 7:
DES-3026:4#show packet ports 7
Command: show packet ports 7
Port number : 7 A B
Frame Size Frame Counts Frames/sec Frame Type Total Total/sec
------------ ------------ ---------- ---------- ------- ---------
64 3275 10 RX Bytes 408973 1657
65-127 755 10 RX Frames 4395 19
128-255 316 1
256-511 145 0 TX Bytes 7918 178
512-1023 15 0 TX Frames 111 2
1024-1518 0 0
C
Unicast RX 152 1
Multicast RX 557 2
Broadcast RX 3686 16
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
60
To Next Page
Loading...
