DES-3000 Series Layer 2 Switch CLI Reference Manual
show sntp
Purpose Used to display the SNTP information.
Syntax
show sntp
Description This command will display SNTP settings information including the
source IP address, time and poll interval.
Parameters None.
Restrictions None.
Example usage:
To display SNTP configuration information:
DES-3026:4#show sntp
Command: show sntp
Current Time Source : System Clock
SNTP : Enabled
SNTP Primary Server : 10.1.1.1
SNTP Secondary Server : 10.1.1.2
SNTP Poll Interval : 30 sec
DES-3026:4#
enable sntp
Purpose Enables SNTP server support.
enable sntp
Description This will enable SNTP support. SNTP service must be separately
configured (see config sntp). Enabling and configuring SNTP support will
override any manually configured system time settings.
Parameters None.
Restrictions Only administrator-level users can issue this command. SNTP settings
must be configured for SNTP to function (config sntp).
Syntax
Example usage:
To enable the SNTP function:
DES-3026:4#enable sntp
Command: enable sntp
Success.
DES-3026:4#
186
To Next Page
Loading...
