DES-3000 Series Layer 2 Switch CLI Reference Manual
5
SWITCH PORT COMMANDS
The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ports config ports [<portlist> | all] {speed [auto | 10_half | 10_full |
100_half | 100_full | {1000_full {[master | slave]}}] | flow_control
[enable | disable] | state [enable | disable] | description [<desc 1-
32> | clear_description]}
show ports
{<portlist>} {[
description | err_disabled]} Each command is listed, in detail, in the following sections.
23
To Next Page
Loading...
