D-Link DES-3026 - Switch - config port_security ports

DES-3000 Series Layer 2 Switch CLI Reference Manual
config port_security ports
Used to configure port security settings.
config port_security ports [<portlist> | all ] {admin_state
[enable | disable] | max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
Description This command allows for the configuration of the port security
feature. Only the ports listed in the <portlist> are effected.
Parameters
ports <portlist> − Specifies a port or range of ports to be
configured for port security.
all − Configure port security for all ports on the Switch.
admin_state [enable | disable] – Enable or disable port security for
the listed ports.
max_learning_addr <max_lock_no 0-10> - Use this to limit the
number of MAC addresses dynamically listed in the FDB for the
ports.
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset] – Indicates the method of locking addresses. The
user has three choices:
Restrictions Only administrator-level users can issue this command.
Purpose
Syntax
 Permanent – The locked addresses will not age out after
the aging timer expires.
 DeleteOnTimeout – The locked addresses will age out
after the aging timer expires.
 DeleteOnReset – The locked addresses will not age out
until the Switch has been reset.
Example usage:
To configure the port security:
DES-3026:4#config port_security ports 1-5 admin_state enable
max_learning_addr 5 lock_address_mode DeleteOnReset
Command: config port_security ports 1-5 admin_state enable
max_learning_addr 5 lock_address_mode DeleteOnReset
Success
DES-3026:4#
161