DES-3000 Series Layer 2 Switch CLI Reference Manual
config snmp system_name
Purpose Used to configure the name for the Switch.
Syntax
config snmp system_name {<sw_name>}
Description
The config snmp system_name command configures the name
of the Switch.
Parameters <sw_name> - A maximum of 255 characters is allowed. A NULL
string is accepted if no name is desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch name for “
DES-3026 Switch”
:
DES-3026:4#config snmp system_name DES-3026 Switch
Command: config snmp system_name DES-3026 Switch
Success.
DES-3026:4#
48
To Next Page
Loading...
