DES-3000 Series Layer 2 Switch CLI Reference Manual
config snmp system_contact
Purpose Used to enter the name of a contact person who is responsible for
the Switch.
Syntax
config snmp system_contact {<sw_contact>}
Description
The config snmp system_contact command is used to enter the
name and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 255 character can be
used.
Parameters <sw_contact> - A maximum of 255 characters is allowed. A NULL
string is accepted if there is no contact.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “
MIS Department II
”:
DES-3026:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3026:4#
config snmp system_location
Purpose Used to enter a description of the location of the Switch.
Syntax
config snmp system_location {<sw_location>}
Description
The config snmp system_location command is used to enter a
description of the location of the Switch. A maximum of 255
characters can be used.
Parameters <sw_location> - A maximum of 255 characters is allowed. A NULL
string is accepted if there is no location desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch location for “
HQ 5F
”:
DES-3026:4#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DES-3026:4#
47
To Next Page
Loading...
