DES-3000 Series Layer 2 Switch CLI Reference Manual
show address_binding
Purpose Used to display IP-MAC address binding entries.
Syntax
show address_binding
[ip_mac {[all | ipaddress <ipaddr>
mac_address <macaddr>]} | blocked {[all | vlan_name
<vlan_name> mac_address <macaddr>]} | ports]
Description This command will display IP-MAC address binding entries set on
the Switch.
Parameters ip_mac – Enter this parameter to view an IP-MAC address binding
entry by entering the following:
1. all – Choose this parameter to view all IP-MAC binding
entries.
2. ipaddress <ipaddr> - The IP address of the device where the
IP-MAC binding is made.
3. mac_address <macaddr> - The MAC address of the device
where the IP-MAC binding is made.
blocked – Choose this parameter to view the IP-MAC address
blocked binding entries by entering one of the following choices to
view it by:
4. all – Choose this parameter to view all IP-MAC binding
blocked entries.
5. vlan_name <vlan_name> - Enter the VLAN name for which
to view the IP-MAC address binding blocked entry. This entry
must be made with the mac_address listed below to view this
blocked entry.
6. mac_address <macaddr> - The MAC address of the device
where the IP-MAC blocked binding is made. This entry is to
be made with the vlan name listed above to view this blocked
entry.
ports – Enter this parameter to view the ports which are enabled
for IP-MAC binding.
Restrictions None.
Example usage:
To show IP-MAC binding entries on the switch:
DES-3026:4#show address_binding ip_mac ipaddress 10.1.1.8
mac_address 00-00-00-00-00-12
Command: show address_binding ip_mac ipaddress 10.1.1.8
mac_address 00-00-00-00-00-12
Enabled ports: 2
IP Address MAC Address
--------------- -----------------
10.1.1.8 00-00-00-00-00-12
Total entries : 1
DES-3026:4#
135
To Next Page
Loading...
