DES-3000 Series Layer 2 Switch CLI Reference Manual
disable autoconfig
Purpose Use this to deactivate autoconfiguration from DHCP.
Syntax
disable autoconfig
Description This instructs the Switch not to accept autoconfiguration instruction from
the DHCP server. This does not change the IP settings of the Switch. The
ipif settings will continue as DHCP client until changed with the config ipif
command.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To stop the autoconfiguration function:
DES-3026:4#disable autoconfig
Command: disable autoconfig
Success.
DES-3026:4#
NOTE: With autoconfig enabled, the Switch ipif settings now define the
Switch as a DHCP client. Use the show switch command to display the
new IP settings status.
show autoconfig
Purpose Used to display the current autoconfig status of the Switch.
Syntax
show autoconfig
Description This will list the current status of the autoconfiguration function.
Parameters None.
Restrictions None.
Example usage:
To show the autoconfig configuration set on the Switch:
DES-3026:4#show autoconfig
Command: show autoconfig
Autoconfig disabled.
DES-3026:4#
58
To Next Page
Loading...
