DES-3000 Series Layer 2 Switch CLI Reference Manual
17
IP-MAC BINDING COMMANDS
The IP-MAC Binding commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> { ports [ portlist | all ] }
config address_binding ip_mac
ipaddress <ipaddr> mac_address <macaddr> { ports
[ portlist | all ] }
config address_binding ip_mac ports
[<port
list> | all] state [enable | disable] show address_binding [ip_mac {[all | ipaddress <ipaddr> mac_address
<macaddr>]} | blocked {[all | vlan_name <vlan_name>
mac_address <macaddr>]} | ports]
delete address-binding [ip-mac [ipaddress <ipaddr> mac_address <macaddr> | all] |
blocked [all | vlan_name <vlan_name> mac_address
<macaddr>]]
Each command is listed, in detail, in the following sections.
131
To Next Page