DES-3000 Series Layer 2 Switch CLI Reference Manual
23
TIME AND SNTP COMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time <date ddmmmyyyy> <time hh:mm:ss >
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min<minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_wday
<start_weekday sun-sat>| s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_week <end_week 1-4,last> | e-wday <end_weekday sun-sat>
| e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth
1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
show time
Each command is listed, in detail, in the following sections.
184
To Next Page
Loading...
