DES-3000 Series Layer 2 Switch CLI Reference Manual
show stp ports
Purpose Used to display the Switch’s current per-port group STP configuration.
Syntax
show
stp ports <portlist>
Description This command displays the Switch’s current per-port group STP
configuration.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
Restrictions None.
Example usage:
To display STP state of all ports, with STP enabled:
DES-3026:4#show stp ports
Command: show stp ports
STP Port Information
----------------------
Port Index : 1
Connection : Link Down
State : Yes
Cost : *2000000
Priority : 128
LBD : No
Edge : No
P2P : Yes
Status : Disabled
Role : Disabled
Forwarding BPDU : Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
80
To Next Page
Loading...
