DES-3000 Series Layer 2 Switch CLI Reference Manual
Example usage:
To configure a syslog host:
DES-3026:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3026:4#
delete syslog host
Purpose Used to remove a syslog host, that has been previously configured,
from the Switch.
Syntax
delete syslog host [<index 1-4> | all]
Description
The delete syslog host command is used to remove a syslog host
that has been previously configured from the Switch.
Parameters
<index 1-4> − Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
DES-3026:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-3026:4#
70
To Next Page
Loading...
