D-Link DES-3026 - Switch - Show Bandwidth_Control; To Configure Bandwidth Control; To Display Bandwidth Control Settings

DES-3000 Series Layer 2 Switch CLI Reference Manual
Example usage:
To configure bandwidth control:
DES-3026:4#config bandwidth_control 1-10 rx_rate 100000 tx_rate 100000
Command: config bandwidth_control 1-10 rx_rate 100000 tx_rate 100000
Success.
DES-3026:4#
show bandwidth_control
Purpose Used to display the bandwidth control configuration on the Switch.
Syntax
show bandwidth_control {<portlist>}
Description
The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
Restrictions None.
Example usage:
To display bandwidth control settings:
DES-3026:4#show bandwidth_control 1-12
Command: show bandwidth_control 1-12
Bandwidth Control Table
Port RX Rate (kbit/sec) TX_RATE (kbit/sec)
---- ------------------------ ----------------------
1 100000 100000
2 100000 100000
3 100000 100000
4 100000 100000
5 100000 100000
6 100000 100000
7 100000 100000
8 100000 100000
9 100000 100000
10 100000 100000
11 no_limit no_limit
12 no_limit no_limit
DES-3026:4#
108