DES-3000 Series Layer 2 Switch CLI Reference Manual
NOTE: The uplink module ports (DES-3010F/FL/G ports 9-10, DES-3018
ports 17-18, DES-3026 ports 25-26) do not support the 802.1X function.
enable 802.1x
Purpose Used to enable the 802.1x server on the Switch.
Syntax
enable 802.1x
The enable 802.1x command enables the 802.1x Port-based or MAC-
based Network Access control server application on the Switch.
Restrictions Only administrator-level users can issue this command.
Description
Parameters None.
Example usage:
To enable 802.1x switch wide:
DES-3026:4#enable 802.1x
Command: enable 802.1x
Success.
DES-3026:4#
disable 802.1x
Purpose Used to disable the 802.1x server on the Switch.
Syntax
disable 802.1x
The disable 802.1x command is used to disable the 802.1x Port-based or
MAC-based Network Access control server application on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Description
Example usage:
To disable 802.1x on the Switch:
DES-3026:4#disable 802.1x
Command: disable 802.1x
Success.
DES-3026:4#
166
To Next Page
Loading...
