DES-3000 Series Layer 2 Switch CLI Reference Manual
25
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static}
config arp_aging time <value 0-65535>
clear arptable
Each command is listed, in detail, in the following sections.
show arpentry
Purpose Used to display the ARP table.
Syntax
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> |
[static]
Description This command is used to display the current contents of the
Switch’s ARP table.
Parameters
<ipif_name 12> − The name of the IP interface the end node or
station for which the ARP table entry was made, resides on.
<ipaddr> − The network address corresponding to the IP interface
name above.
static − Displays the static entries to the ARP table.
Restrictions None.
Example Usage:
To display the ARP table:
194
To Next Page
Loading...
